Connecting The Mf Control - Abicor Binzel MF Control Manual De Instrucciones

6 Commissioning
6 Commissioning

6.1 Connecting the MF Control

The MF Control must only be used in conjunction with the eBOX MFS-V3 master feeder system.
NOTICE
• Please take note of the following instructions:
 5.2 Control elements on page EN-7
• The system may be installed and commissioned only by qualified personnel (in Germany, see TRBS 1203).
Pin assignment for
M12 plug
Carry out each step in accordance with the figure below:
Fig. 3 Connecting the MF Control
EN - 8
Assignment (Ethernet, power supply), 8-pin, A-coded, view from side
of pin
1 RX+
2 RX−
3 TX+
4 24 VDC+
5 24 VDC+
6 TX−
7 24 VDC−
8 24 VDC−
A
B
MF Control
BAL.0532.0 • 2018-08-16