Maintenance / Cleaning; Troubleshooting - Vortice TELENORDIK 5TR Manual De Instrucciones

3) Test the ceiling fan functions, by pressing buttons
(1 - 2 - 3 - 4 - 5) on the remote control transmitter,
according to the speed, and test the reversing
function using the
will flash and a beep will sound to confirm that the
command has been received).
4) Test the fan light on/off function (if there is one),
by pressing on the transmitter.
5) Press "0" on the transmitter to stop the fan; if
necessary, press again to turn off the fan light.
Check any other switches, inverters and buttons, to
ensure the whole system is working properly.
Timer function
This remote control is equipped with a timer function,
allowing the fan to be operated at the speed and in
the direction selected for approximately 1 hour.
To start the timer function, turn the fan on and press
. The green LED on the receiver will light up to
indicate that the function has been activated. This
green LED will remain lit while the timer is in
operation (approx. 1 hour). After this it will go out.
To start a new timer cycle, select the function again
by pressing .
10
buttons (the red indicator light
If desired, you can change fan speed and/or
direction after the timer function has been started;
this action will not affect the timer period, which will
still be approximately 1 hour.
If you wish to stop the timer function before the end
of the period set, simply press "0".
When the appliance is turned off by pressing "0", all
functions except the light will be switched off.
The reception distance between transmitter and
receiver (with fully charged batteries in the
transmitter) is approximately 13 m.
When installing a number of fans with TELENORDIK
5TR, it is recommended that the appliances be fitted
at least 3 m from each other.

Maintenance / Cleaning

Before carrying out any type of cleaning or
maintenance operation, turn the appliance off at the
main switch and, if equipped with a plug, unplug it
from the power supply.
Do not use powders, abrasive substances, solvents
or alcohol to clean the exposed surface of the
appliance.