Fitting The Glass Facia; Fitting The Side Panels - Lennox Scandium-NG Instrucciones De Instalación Y Operación

15.0 ASSEMBLY OF THE GLASS FACIA - (continued)
2. Slide on the side pieces ensuring that the grille fixing holes (shown)
are aligned towards the top of the glass facia (as shown in figure 11).
Grille fixing holes
Figure 11
3.Ensure the sides are neatly aligned with the glass and secure the
sides using two M6 screws for each side as shown in figure 12. Do
not overtighten the screws.
Figure 12
4. Position the grille within the two side pieces ensuring a neat fit.
TOP
5. Secure the grille in position using two M6 screws and two no. 8 self
tapping screws as shown in figure 14.

16.0 FITTING THE GLASS FACIA

The glass facia panel is supported by four M6 screws which protrude
from the front of the outer casing. Insert the M6 retaining screws and
ensure they are unscrewed approximately 1/8" so the keyhole shaped
holes may engage, and the facia can be hooked on. Ensuring that the
corresponding keyhole shaped holes engage the screwheads fully.
Refer to figure 15.
Figure 15
Figure 13

17.0 FITTING THE SIDE PANELS

Remove the
assemblies from the protective
packaging and fit onto the sides of the
firebox as shown. Insert the M6
retaining screws in the sides of the
Figure 14
firebox and
unscrewed approximately 1/8" so the
keyhole shaped holes may engage,
and the sides can be hooked on.
8
two side panel
Figure 16
ensure they are
Note : Front frame/facia not shown
for clarity.