User Information; Important Safety Instructions - Marshall Monitor Manual De Instrucciones

Tabla de contenido

Publicidad

Marshall is a trademark of Marshall Amplification Plc. Permission granted. Design of product and packaging are intellectual properties of Zound
Industries International AB. © 2017 Zound Industries. All rights reserved. Produced in China. Zound Industries International AB makes no claims of
compatibility of the microphone and remote with any mobile device. For use with electronic devices connected via unprotected two-way standard
3.5 mm plug; Zound Industries International AB makes no claims of this product's compatibility with any electronic devices.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Zound Industries
International AB is under license. Qualcomm aptX is a product of Qualcomm Technologies International, Ltd. Qualcomm is a trademark of
Qualcomm Incorporated, registered in the United States and other countries, used with permission. aptX is a trademark of Qualcomm Technologies
International, Ltd., registered in the United States and other countries, used with permission.

USER INFORMATION

This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic equipment. This product was produced after Jan 1 2006.
To prevent possible hearing damage, do not listen at high volume levels for long periods. WBCV – Monitor Bluetooth®: 113 mV

IMPORTANT SAFETY INSTRUCTIONS

WARNINGS
Contains small parts which may be a choking hazard.
Not suitable for children under age three.
• Set a low volume setting before using the headphones.
• Long-term exposure to loud music or sounds may cause hearing damage. It is best to avoid high volume levels when using these
headphones, especially for extended periods.
• Do not use these headphones when operating a motor vehicle, a bicycle, machinery or where your inability to hear outside sounds may
present a danger to you or others.
• Do not drop, sit on, or allow the headphone to be immersed in water.
• Keep away from fire, water, and high voltage equipment.
• Do not modify, disassemble, open, drop, crush, puncture, shred the headphone or heat above 140°F (60°C).
• Do not short-circuit the included battery or its cells.
• In the event of a battery cell leaking, do not allow the liquid to come in contact with the skin or eyes.
CAUTIONS
• Using these headphones limits your ability to hear noises around you, regardless of listening volume. Please use caution when using these headphones.
• The pads that accompany these headphones may deteriorate over time. Please make sure to use suitable pads on the headphones at all times.
• FCC ID: 2AAGF-MONITOR and IC ID: 11153A-MONITOR, are located under the right ear cushion. To remove, hold the ear cap and remove the
magnetic ear cushion.
007
ENGLISH
FCC WARNING
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Note: This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC WARNING
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the
device. The device is compliance with RF field strength limits, users can obtain Canadian information on RF exposure and compliance. This Class B
digital apparatus complies with Canadian ICES-003. CAN ICES-3(B)/NMB-3(B).
ADMINISTRATIVE REGULATIONS ON LOW POWER RADIO WAVES RADIATED DEVICES WARNING:
ARTICLE 12 Without permission granted by the NCC, any company, enterprise, or user is not allowed to change frequency, enhance transmitting
power or alter original characteristic as well as performance to an approved low power radio-frequency devices. ARTICLE 14 The low power
radio-frequency devices shall not influence aircraft security and interfere legal communications; If found, the user shall cease operating
immediately until no interference is achieved. The said legal communications means radio communications is operated in compliance with the
Telecommunications Act. The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM
radio wave radiated devices.
DECLARATION OF CONFORMITY:
Hereby, Zound Industries International AB, declares that this product is in compliance with the essential requirements and other
relevant provisions of Directive R&TTE 1999/5/EC and the RoHS directive 2011/65/EU. For the declaration of conformity, please
visit the following website: http://www.marshallheadphones.com.
For any questions or concerns contact support@marshallheadphones.com
Zound Industries International AB • Centralplan 15 • 111 20 Stockholm • Sweden
ENGLISH
008

Publicidad

Tabla de contenido
loading

Tabla de contenido