Electrical Connection; Operation; Cleaning - Profi Cook PC-SM 1005 Instrucciones De Servicio

Блендер PROFI COOK PC-SM 1005
Купить в интернет-магазине http://clatronic-shop.com.ua
1. Press both buttons (6) simulta-
neously.
2. Attach the motor casing (5)
on the blender (7) until it
clicks into place. Observe the
recesses on the blender.
3. Release the buttons. Motor
casing and blender are tightly
connected.
To detach press and hold both buttons simultane-
ously and pull the blender from the motor casing.

Electrical connection

1. Ensure that your mains power corresponds
with the specifications of the appliance. The
specifications are printed on the type label
2. Connect the mains cable to a properly installed
and earthed 220-240 V~, 50/60 Hz wall outlet.

Operation

1. Submerge the entire blender head in foodstuff
or beverage. Keep the appliance upright. In
this way you avoid spatters.
2. Hold the grip with one hand in such way that
you can press one of the push buttons (I or II)
at the same time.
Pushbutton I (3): This switches on the mini-
mum speed.
Set the continuously vari-
able speed with the control
knob (2).
Pushbutton II (4): This provides the maxi-
mum speed and cannot be
regulated.
3. Pulsed mode is switched on by pressing the
appropriate pushbutton at intervals and then
releasing it again.
4. The device switches itself off when the button
is released.
WARNING: Risk of injury!
The motor overtravels. Wait until the knife comes
to a complete standstill.
NOTE:
Interrupt the process if the maximum speed is
too slow.
Reduce the quantity of the food being mixed.
First break up any solid food.
5. Pull out the plug from the socket after use.
6. After cleaning hang the appliance on its eyelet
(1).

Cleaning

Pre-Cleaning After Use
Fill a container with hot water and let the blender
run in it for pre-cleaning as described under "Op-
eration".
WARNING:
• Always remove the plug before cleaning!
• Under no circumstances should you immerse
the motor housing in water in order to clean it.
Otherwise this might result in an electric shock
or fire.
CAUTION:
• Do not use a wire brush or any abrasive
items.
• Do not use any acidic or abrasive detergents.
• Wipe the casing with a dampcloth.
• If you want to clean the hand blender (mixing
rod) thoroughly, detach it from the motor housing
as described under "Assembly / Dismantling".
Cleaning In Sudsy Water
WARNING: Risk of injury!
The blade of the bar mixer is very sharp! Please
be very careful.
You can briefly rinse the blender in warm sudsy
water. Afterwards rinse in clean water. Dry the
blender thoroughly.
Cleaning In the Dishwasher
The blender is dishwasher-safe. Ensure not to
overdose the cleaning agents (detergent, salt and
rinse aid).
29