Panasonic ER-GN30 Manual De Operación página 6

3
3
Insert the tip of the
outer blade into your
nostril or aural cavity.
• Insert it slowly so as not to
injure your nostril or aural
cavity.
4
4
Cut the nose hair and ear hair by moving the
appliance.
• Move it slowly so as not to injure your nostril or aural cavity.
• Cut only the nostril hair around the entrance using the tip
(approx. 5 mm) of the outer blade (metallic part).
• Some trimmings may remain inside your nostril or aural cavity
after cutting, so remove them using a tissue or similar.
• The outer blade surface may get a little warm during use, but
performance will not be affected.
Outlining your eyebrows, moustache, or beard
You cannot trim the hair to length with this appliance.
It is not suitable for the hair below 1/64" (0.5 mm).
1
1
Check that the wash switch
ring is not set to " ".
2
2
Slide the power switch to
the "1" position to turn the
appliance on.
3
3
Place the tip of the outer
blade against the hair
(eyebrows, moustache, or
beard) you would like to
cut.
• Press the outer blade softly
so as not to injure your skin.
6
1
2