Safety Instructions - TECshow BEAMER 17R Manual De Usuario

3. Safety instructions

Please conserve this manual as operation guidance. If
you sell this product to other user, please make sure
that they also receive this user manual.
1. Always make sure that you are connecting
to the proper voltage and the line voltage not
higher than stated on the decal or rear panel
of the fixture.
2. This lighting is intended to indoor use only.
To prevent risk of fire or shock, do not ex-
pose fixture to rain or moisture. Make sure
there are no flammable, explosive or corrosive
material in 10 meters around while operating.
3. The unit must be installed in a location with
adequate ventilation, at least 5m away from
adjacent surfaces. Be sure that no ventilation
slots are blocked.
4. Fixture may carry high heat, do not aim at
objective exceeding 2 minutes.
5.
Safe wire should be used to install machine.
Bearing of safe wire should be 3 times of the
machine weight.
6. Always disconnect from the power source
before servicing or replacing fuse/lamp and
be sure to replace with same fuse/lamp size
Caution
There are no user serviceable parts inside
the unit. Do not open the housing or attempt
any repairs yourself. If exceptional problem
happen, please contact related a er-sale de-
partment or manufacturer. Any damage that
cased by violating this manual is out of insur-
ance, our company will not take the respon-
sibility.
P. 4
BEAMER 17R
ENGLISH VERSION
and type. Cut o power before moving, repair-
ing and cleaning the machine.
7. To avoid electric shock, all fixtures must be
connected to circuits with a suitable ground.
8. Always secure fixture using a safety chain and
carrying handles. Never carry the fixture
by its cord.
9. Do not operate at ambient temperatures
higher than 104F(40C).
10. In case of failure or misfunction occurred, stop
using the unit immediately. Never try to repair the
unit by yourself. Repairs carried out by unskilled
people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance
center. Buy the same spare parts/components
from manufacturer directly.
11.
Make sure the power cord is never damaged.
12. Avoid direct eye exposure to the light source
while it is on.
13. Do not power on and power o the fixture in a
short time.
14. When use DMX controller, please make sure
that there is no interference sources (e.g. inter-
com, high frequency radio waves and radiation.