Super Ego 8870902 Manual De Instrucciones página 25

Daily inspection, maintenance
WARNING
Before performing inspection and maintenance, pull
the power supply plug out of the socket.
Sudden operation may cause accidents or injury.
1) Inspection of screws (A)
Inspect screws and nuts on each part of the machine,
and re-tighten if loose.
2) Inspection of rollers (B)
Check that rollers matching the type of pipe are used.
With incorrect rollers, normal grooving is impossible.
Check for chips and cracks m the rollers.
With broken rollers, precise grooving is impossible,
and the machine will be damaged.
Replace with new rollers.
A. Overall inspection
User's manual
3) Periodic replenishment of grease (C)
Periodic greasing is required. Unless grease is replaced,
the machine may wear out sooner than it should.
When replacing the roller set, replenish the upper
roller bearing and main body bearing with sufficient
grease.
Replenish the feed screw and roller shaft grease nipple
with grease once a month.
Oil the leading screw and the arbor once a month via
the greasefittings. If this is not done, the roller may
jam and render the machine inoperative.
4) Cleaning after use (A)
To prolong the life of the machine, be sure to clean
the machine and the rollers every time after use.
5) Whenever the roller-spindle assembly is changed,
check that it is well oiled, and if necessary add oil.
C. Replenishment of grase
B. Inspection of rollers
Requesting repairs
This machine is produced with great precision;
therefore, should the machine fail to operate normally,
do not repair it by yourself, but call us for repairs.
If parts are required or if you have any questions,
please contact us, at your earliest convenience.
25
GB