Bartscher 105L Manual Del Usario página 36

Setting the desired temperature (desired value)

The optimum temperature has been set at the factory and corresponds to the working
temperature between 0 °C to 12 °C inside the refrigerated display (depending on the
external temperature).

To set or change the desired value:
 briefly press the button
 increase or reduce the temperature value as needed using the buttons
 confirm the value entered by pressing the button
NOTE!
If no button is pressed in the next 10 seconds, the digital display will
show the temperature inside the refrigerated display.
The display shows the value of temperature which is measured near the
temperature sensor and is used for controlling the compressor.
Automatic defrost
The device's automatic defrost cycle runs 3 times every 24 hours.
Manual defrost
When the cooling capacity decreases, it is necessary to perform the manual
defrosting. To start the defrosting, press the manual defrost button
pressed for 6 seconds. The LCD defrost indicator „
defrost cycle will start in 8 hours.
- 32 -
, the value on the digital display will start flashing;
.
and hold it
" will come on. The next
or ;