Installation - Bartscher GWH2 Instrucciones De Uso

5.1.2 Installation

•
DO NOT install the device in toxic or explosion-threatened environment.
•
DO NOT install the device in the vicinity of flammable materials, like gasoline, glue,
liquid gas, paper, etc.
•
DO NOT install the device in wet or humid room or conditions, like in the rain or next
to the water, etc.
•
The installation must be performed by the authorized person. Install the device
according to the national safety standards for the gas-powered devices.
•
Place the device in well-ventilated room with permanent ventilation ducts in order to
assure sufficient air replacement and for safe work station. If the gas cooker is not
connected directly with the extraction system, place it under the hood of high
efficiency in order to remove the combustion gases and cooking vapours.
•
The following is valid for the housing types listed below while following the national
regulations:
- A1: The device without air intake or connection with the extraction system or
other device for removing the combustion products from the room.
The combustion air and gases are mixed in the same room.
•
Make sure that no objects next to and under the gas cooker limit the amount of air
required for combustion.
•
Remove all flammable materials from the cooker vicinity.
•
In case of free standing device maintain at least 20 cm of space to the side walls
and 10 cm to the back wall. It is especially important when the device is positioned
next to the wall and is not protected by the refractory material.
•
Position the device separately or next to another device of the same type.
•
Position the device on a stable, even and flat surface near the gas connection.
•
Remove the protective foil before start-up. Remove all stickers using appropriate
solvent.
•
Remove the package material according to the national regulations.
CAUTION!
Never remove the rating plate and any warning signs from the device.
- 44 -