Manufacturer's Warranty; Fcc Statement (Applicable In Us) / Ic Statement (Applicable In Canada) - Hilti GX-IE Manual Del Usuario

Trouble or fault
No fastener is driven.
Fastener does not penetrate
deeply enough into the mate-
rial.
Surface of the material is too
uneven.
12 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
13

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
14

FCC statement (applicable in US) / IC statement (applicable in Canada)

This device complies with Part 15 of the FCC Rules and RSS-210 of IC. Operation is subject to the following
two conditions:
1. This device shall cause no harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
10 English
Printed: 07.05.2018 | Doc-Nr: PUB / 5426547 / 000 / 00
Possible cause
Incorrect piston position due to
foreign-matter build-up
Foreign object in the area of the
fastener guide.
Electronic fault.
The system is unsuitable. The sup-
porting material is too hard.
Drive energy too low.
Surface of the material is too un-
even.
Action to be taken
▶ Clean the fastening tool.
▶ Remove foreign objects from
the area of the fastener guide.
▶ Remove the gas can and then
reinsert it. If the problem
persists, use a new gas can.
▶ Remove the battery and then
reinsert it.
▶ Switch to a Hilti DX system.
▶ Check the tool. Contact Hilti
Service.
▶ Switch to a Hilti DX system.
2208858
*2208858*