Haier HEBF100BXS Manual Del Usuario página 12

Centro de la bebida
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
STEP 2 - REVERSE DOOR
8. Using a putty knife, gently pry upward on
the back edge of the top hinge cover to
remove.
9. Using a 5/16" hex-head wrench, remove
the two screws fastening the top hinge,
and then remove the hinge.
10. Using the putty knife remove the hole plug
from the door and the two hole plugs
from the cabinet, and then replace
them in the holes remaining from
removing the top hinge.
11. Reinstall the top hinge on the opposite
side.
12. Replace the top hinge cover.
13. Stand the beverage center upright, and check that the door is aligned
with the cabinet.
IMPORTANT: If the beverage center has been placed in a horizontal position
for any period of time, wait 4 hours before plugging in the beverage center
to allow the refrigerant to settle.
NOTE: If the top of the door is not
aligned with the cabinet, loosen the
top hinge screws, adjust door and
re-tighten top hinge screws.
12
(Optional) (Cont.)
Hinge Cover
Top Hinge
Screws
Hole
Plugs
Top Hinge
Screws
49-60809 Rev. 2

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido