Bresser 7007400 Manual De Instrucciones página 22

cause interference. This can include devices used in the neighborhood
as well.
Main unit channel setting
1. The main unit can be connected with a maximum of up to 3
transmitters.
2. Press the touch control CH/
each channel. The main unit will display the information of the
corresponding transmitter. When the symbol
channel information the automatic display rotation is activated. The
display changes between the information of the connected remote
sensors every 10 seconds.
NOTE!
The function to change the channels by pressing the CH/
be used only if more than one remote sensor is connected with the
main unit. Otherwise this function is disabled.
Set current time and measurement data storage
1. Press and hold the °C/°F/SET (7b) button in normal display mode for 3
seconds to enter into time setting mode.
2. The value to be set will start flashing.
3. Press MEM/
4. Press °C/°F/SET button to confirm and go to the next value to be
changed.
5. The setting order is hour >> minutes >> 12 or 24 hour mode >> 24 hour
MIN/MAX measurement data storage ON/OFF
NOTE!
When choosing ON for 24 hour measurement data storage all stored
MIN/MAX values for temperature and humidity will be deleted daily at
0:00 h! When choosing OFF the data will be stored indefinitely until a
battery change is required.
6. If there is no operation for 20 seconds, the existing setting will be
saved and the device returns to normal display mode. Press °C/°F/SET
button again to confirm and exit setting.
Background illumination
Press the button for the background illumination (12) to turn it on. The
background illumination will be turned off automatically after approx. 5
seconds.
22
(7a) or CH/ (7c) to change the value.
(7c) to switch between the displays of
is displayed near the
button can