Bresser 7007400 Manual De Instrucciones página 23

Sensor function
1. Move the CH switch to the position (1-3) that corresponds with the
channel which will be used for transmission (select channel 1 if only
one remote sensor is connected). If you would like to connect more
than one remote sensor with the main unit, different channels need to
be selected for each sensor.
2. Press °C/°F to change the temperature display of the transmitter
3. Once the weather station receives radio signals from the sensors, the
alternating temperature values of the different channels will be updated
on the weather station every 1-2 minutes.
TROUBLESHOOTING
Signal disconnection
If without obvious reasons the display of the outdoor temperature goes
blank, please check the following:
1. The remote unit is still in place.
2. The batteries of both the remote unit and main unit are not empty.
Replace batteries with new ones if necessary.
NOTE!
When the temperature falls below freezing point, the batteries of
outdoor units will freeze, lowering their voltage supply, effective range,
and life span.
3. All units required are within range and the path is clear of obstacles and
interference. Shorten the distance if necessary.
Transmission collision
Signals from other household devices, such as door bells, home security
systems and entry controls, may interfere with those of this product and
cause temporarily reception failure. This is normal and does not affect the
general performance of the product. The transmission and reception of
temperature readings will resume once the interference recedes.
DE
GB
FR
NL
IT
HU
ES
23