English; Safety Notes - Bosch GCC 30-4 Professional Manual Original

OBJ_BUCH-2515-003.book Page 22 Tuesday, April 25, 2017 8:11 AM

22 | English

English

Safety Notes

All instructions must be read and observed in order to enable
work with the GCC 30–4 Professional to be carried out safely.
Store these instructions in a safe place and provide them when
transferring the GCC 30–4 Professional or any object identified
using it to a third party.
 It must be ensured that attaching the GCC 30–4 Professional does not limit
the proper and safe use of the object to be identified at any time. Attaching a
GCC 30–4 Professional at the following locations is prohibited (for examples, see
image D):
– Protective devices,
– Ventilation grills,
– Components that are actively operated (e.g. on/off switches, controllers, in-
lets, etc.)
– Moving or rotating components,
– Type plates,
– Operating panels and grip surfaces,
– Softgrip surfaces,
– Surfaces in the direct vicinity of sparks,
– Surfaces that are exposed to strong mechanical or thermal effects,
– Surfaces that ensure that the object is positioned safely,
– Surfaces that could be damaged by adhesive components.
 The following locations are suitable for attaching a GCC 30–4 Professional (for ex-
amples, see image E):
– Surfaces where attaching the GCC 30–4 Professional does not prevent or com-
plicate the operation of the object,
– Surfaces that will not be exposed in the event that the identified object falls
over,
– Surfaces with the minimum possible curvature.
 Only use the two-part adhesive provided and observe all processing instruc-
tions from the manufacturer when attaching to the object. The use of adhe-
sives with a different composition may either cause damage to the object to be
identified or fail to create a permanent bond between the GCC 30–4 Professional
and the object.
1 609 92A 3W4 | (25.4.17) Bosch Power Tools