Setting The Timer - cecotec CONGA 899 SLIM Manual De Instrucciones

ENGLISH
When it finishes cleaning, it will go back to the charging base automatically.
Tips: The machine will automatically enter edge-cleaning
SINGLE ROOM CLEANING MODE
This cleaning mode is used when the user wants only one room to be cleaned.
When it finishes cleaning, the robot will stop. Close the doors for the cleaner to
work better.
BACK TO CHARGING BASE MODE
The robot goes back automatically to the charging base when the battery is
under 15%. To send the cleaner back to the charging base press the button on
the remote control.
MODE: TIME SCHEDULING
To make the cleaning easier, the appliance has a timer mode that allows you to set the time and
day of the week in which the robot should clean.
• The time options on the remote control are 12:00 am – 11:59 pm y 12:00 pm – 11:59 am.
• Before adjusting the time and settings from the robot, make sure the cleaner is on "I" and the
button on the control panel is green/blue. If the light is not on, turn the cleaner on from
the control panel or the remote control.
SETTING THE CURRENT TIME AND DAY OF THE WEEK
• Press the button. The day of the week and the
• Select first the day of the week. In order to do that, use the
current day.
• To change to the time, use the
procedure with the minutes: press
• Once set, press OK or
IMPORTANT: the day of the week will not show up on the display. To check it has been saved, press
and make sure the day of the week is correct.

SETTING THE TIMER

• The day of the week and time must be properly configured for the timer to work properly.
Check how to set the time and day of the week in the the previous section ("Setting the
current time and day of the week").
• Press the button. The
• Select the day of the week you want the appliance to clean using
• To change to the time, use the
procedure with the minutes: press
• To save this setting, point the remote control towards the cleaner and press OK. The cleaner
will emit a "beep" to signal that the settings have been properly saved. In case the "beep" is
not emitted, the settings have not been saved.
22 CONGA 899 SLIM
button. Use
, then
to confirm.
and day of the week icons of the display will start blinking.
button. Use
, then
icons on the display will start blinking.
to select the current time. Repeat this
to choose the minutes.
to select the desired time. Repeat this
to choose the minutes.
buttons and search the
.