GRE POOL EXPERT Manual De Instrucciones página 2

ENGLISH
Solar heater for swimming pools
Method of use
Operation
A filtering unit for the pool that allows heating the water with a solar heater.
The minimum power of the pump should be 2,000 l/h. The solar heater should be situated next to
the swimming pool towards the south with a 30º inclination.
The foldable feet of the heater allow placing the heater with the correct inclination.
Solar energy accumulates below the transparent lid and later is distributed toward the water
supply tube. The heating that is noted at the outlet from the solar heaters depends on the speed
of the water flow.
Materials
Sun is needed to start the solar heater. This may remain connected although there is no sunlight as
it only causes a very slight loss of power when it is connected.
Current filtering units can be used with the 32 and 38 mm hosepipe connectors.
Additionally the solar heater can also be installed on the roof of your garden house. All that is
necessary is to ensure that the filtering equipment will have sufficient power at that height or that
the filter is well equipped to resist higher pressures (1m height represents 0.1 bar of pressure). If
additional sections of tubing are used or the position is higher, the power of the pump will be
reduced.
Always face the heater to the south and make sure it receives sunshine all day.
The foldable feet will facilitate obtaining the correct 30º inclination. We recommend using the
same angle for roof-top installations.