Use Your Baby Monitor - Philips AVENT SCD505 Manual Del Usuario

5 Use your baby
monitor
Link the parent unit to the baby unit:
1
Press and hold
seconds.
»
The baby unit turns on, and all indicators
on the baby unit light up briefly.
2
Press and hold
two seconds.
»
The parent unit turns on, and all
indicators on the parent unit light up
briefly.
»
The link indicator flashes red and the
parent unit starts to search for the
baby unit.
»
When link is established, the
indicator lights up green.
on the baby unit for two
on the parent unit for
link
»
If no link is established, the
indicator flashes red. The parent unit
beeps from time to time.
Position the baby monitor:
1
Keep the baby unit and the mains cord
at least 1 metre/3.5 feet away from your
baby.
2
Keep the parent unit at least 1.5 metres/
5 feet away from the baby unit to prevent
acoustic feedback.
> 1.5m/5ft
3
Use the parent unit in the operating
range of the baby monitor.
Tip
• It takes less than 15 seconds to establish the
link between the parent unit and the baby unit.
•
When the parent unit is out of range of the
baby unit, the parent unit beeps from time
to time. The link indicator on the parent unit
flashes red.
• The battery indicator flashes red and a beep
tone occurs 30 minutes before the batteries
run out of power.
link
> 1m/3.5ft
EN 9