Safety And Installation Instructions - Dometic MWE 4104 Instrucciones De Montaje Y De Uso

Safety and installation instructions

I
NOTE
Supplementary information for operating the product.
2 Safety and installation instructions
The following texts are only a supplement to the illustrations on the
supplementary sheet. They do not contain the full installation and
operating instructions. Please observe the illustrations on the
supplementary sheet.
Please observe the prescribed safety instructions and stipulations from the
vehicle manufacturer and service workshops.
Observe the applicable legal regulations.
The manufacturer accepts no liability for damage in the following cases:
• Damage to the product resulting from mechanical influences and incorrect
connection voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
!
WARNING!
• Secure the parts of the blind spot assistant which are installed in the
vehicle in such a way that they cannot become loose under any cir-
cumstances (sudden braking, accidents) and cause injuries to the
occupants of the vehicle.
• Do not install the parts of the blind spot assistant anywhere in the vehi-
cle where an airbag may open. This could cause injury if the airbag
deploys.
• The blind spot assistant is intended as an additional aid, which means
it does not relieve you of the obligation to take due care when maneu-
vring.
A
NOTICE!
• If you would like to install the sensors on metal bumpers, you will
require suitable adapters (not included in the scope of delivery).
• Do not expose the control electronics to dampness.
• Do not install the control electronics near any other control modules.
• The sensors may not cover signal lamps.
4
MWE4104
EN