Important Safety Instructions - Makita AN250HC Manual De Instrucciones

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency
5. Adjuster
6. Too deep
7. Flush
8. Too shallow
9. Screw
10. Hook
SPECIFICATIONS
Min. hose diameter
Dimensions (L X W X H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.................. Read instruction manual.
................. Wear safety glasses.
Intended use
The tool is intended for securing a thin steel plate to the
concrete.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO
REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
1. For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
2. Always wear safety glasses to protect your eyes from
dust or pin injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
6
Explanation of general view
11. Contact element
12. Nose adapter
13. LOCK position
14. FREE position
15. Latch lever
16. Door
17. Driver channel
18. Trigger
19. Workpiece
20. Thin steel plate
Model
Air pressure
Nail length
Nail capacity
Net weight
3. For Australia and New Zealand only
END105-2
Always wear safety glasses and face shield to protect
your eyes from dust or pin injury. The safety glasses
and the face shield should conform with the
requirements of AS/NZS 1336.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
(Fig. 1)
ENE072-1
4. Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
5. Rushing the job or forcing the tool is dangerous.
Handle the tool carefully. Do not operate when under
ENB115-1
the influence of alcohol, drugs or the like.
6. General Tool Handling Guidelines:
(1) Always assume that the tool contains fasteners.
(2) Do not point the tool toward yourself or anyone
whether it contains fasteners or not.
(3) Do not activate the tool unless the tool is placed
firmly against the workpiece.
(4) Respect the tool as a working implement.
(5) No horseplay.
(6) Do not hold or carry the tool with a finger on the
trigger.
(7) Do not load the tool with fasteners when any one
of the operating controls is activated.
(8) Do not operate the tool with any power source
other than that specified in the tool operating/
safety instructions.
21. Penetration amount into concrete
22. Cap
23. Drain cock
24. Air filter
25. Oiler
26. Pneumatic oil
27. Thinner
28. Stove
AN250HC
1.18 - 2.26 MPa (11.8 - 22.6 bar)
19 mm - 25 mm
Sheet-collated coil pin
100 pcs
5 mm
295 mm X 128 mm X 291 mm
2.1 kg