Operation; Energy Saving Tips - Dometic RH 430STE Instrucciones De Montaje

RH430, RH440
6.1 Changing the decorative plate
You can change the decorative plate: fig. 4 to fig. 7, page 4.
6.2 Mounting the sliding hinge (optional)
You can mount a sliding hinge that allows the cooling device door to be opened at
the same time as the door of the built-in cabinet: fig. 8, page 5, to fig. m, page 8.
6.3 Reversing the door
Reverse the door as follows: fig. n to fig. r, page 9.
Suitable for doors with sliding hinge only: fig. p to fig. q, page 9.
7

Operation

!
CAUTION! Health hazard!
Food may only be stored in its original packaging or in suitable
containers.
I
NOTE
• Before starting your new cooling device for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter "Cleaning and maintenance" on
page 17).
• A few water drops may form inside the cooling device if it has been
cooling for a lengthy period. This is normal because the moisture in
the air condenses to water when the temperature in the cooling
device falls. The cooling device is not defective. Wipe it out with a
dry cloth if necessary.
7.1

Energy saving tips

• Choose a well ventilated installation location which is protected against direct
sunlight.
• Allow warm food to cool down first before placing it in the cooling device to
keep cool.
• Do not open the cooling device more often than necessary.
• Do not leave the cooling device open for longer than necessary.
EN
Operation
15