Instructions For Installation - Sammic L-EQ Manual De Usuario

1. Unpack the scale and check the conditions of the product. If
it is damaged report it inmediately to your authorized
distributor.
2. Place the scale where there is not any movement or
vibration, make sure it is leveled adequately checking that
the four leveling bases are supporting the scale over the
surface were it has been placed and if the level bubble
(under the plate) is centered, to adjust, tighten or loosen
the leveling bases until the bubble is in the center of the
circle.
3. Connect the ac/dc power supply to 120 vac outlet or 220
vac
4. Power on the scale, your scale will display zeros, being
ready to use.
IMPORTANT NOTE: If your scale displays "HELP" after you followed the previous steps and after
the initial countdown, it means that it was handled roughly and/or got hit during the shipment, wich
cause irreversible damage in its operation. Call your authorized distributor. Is possible that the scale
displays "HELP" when you turn it on with weight on the plate, when this happens, remove the weight
and turn the scale off and then turn it on
6 ENGLISH
III.-INSTRUCTIONS FOR INSTALLATION