Securing The Flyscreen In The Vehicle; Completing Installation - Dometic FlyTec FT 200 Instrucciones De Uso

Installing the flyscreen
A
NOTICE! Risk of breaking the lower plastic slider
Be careful when you are lifting and positioning the flyscreen and do not
bend or tilt the skirting board.
➤ Have two people carefully lift the pre-assembled flyscreen and position it in the
vehicle.
Adjusting the top guide rail
➤ Check whether the contour and position of the upper guide rail fit the vehicle
(see enlarged inset in fig. 7, page 5). You may need to adjust the upper guide
rail by cutting the two upper legs.
5.4

Securing the flyscreen in the vehicle

A
NOTICE!
•
Choose suitable screws depending on the floor and roof
construction.
•
Make sure that you do not drill through the floor and roof.
Securing the skirting board and upper guide rail
➤ Align the position of the cassette profile perpendicular to the skirting board and
the upper guide rail.
➤ Secure the skirting board to the bottom plate (fig. 6, page 5) with five counter-
sunk screws (Ø 4 mm).
➤ Secure the upper guide rail to the vehicle (fig. 7, page 5) with four countersunk
screws (Ø 4 mm).
5.5

Completing installation

Riveting the cassette profile with the cover profile for the C pillar (fig. 8,
page 6)
➤ Put all the blind rivets (4 x 8 mm with stainless steel mandrel) through the drill
holes and rivet the components using a hand riveter.
12
Dometic FlyTec FT200
EN