Using The Flyscreen; Cleaning And Maintenance - Dometic FlyTec FT 200 Instrucciones De Uso

Dometic FlyTec FT200
Tensioning the guide cables
A
NOTICE!
The tension of the cables affects the guidance and smooth running of the
handle strip. By changing the tension of the upper and lower cable, you
can adjust the parallel orientation of the handle strip to the right door
edge. Do not tension the cables more than 25 Newton.
➤ Tension the guide cables on the deflection screws on the skirting board and the
top guide rail (fig. 9, page 6).
➤ Secure the safety clips onto the deflection screws each with a screw
(M2.5 x 6 mm) (fig. 9 1 and 2, page 6).
6

Using the flyscreen

A
NOTICE! Beware of damage!
The sliding door of the vehicle may be closed only when the flyscreen is
fully open.
Closing the flyscreen
➤ Pull the handle strip on the flyscreen to close the flyscreen (fig. 0, page 7).
Opening the flyscreen
➤ Pull the handle strip on the flyscreen to open the flyscreen (fig. 0, page 7).
7

Cleaning and maintenance

A
NOTICE! Damage hazard
Do not use sharp or hard objects or cleaning agents for cleaning as these
may damage the product.
➤ Occasionally clean the product with a damp cloth.
➤ Spray the guide rails on the sliding surfaces periodically with small amounts of
silicone spray to achieve the easiest possible sliding of the cassette profile in the
guide rails.
EN
Using the flyscreen
13