Installation; Prescribed Installation Method - Dometic COOLAIR SP 950I Instrucciones De Montaje

Installation

6 Installation
A
NOTICE!
The parking cooler may only be installed by qualified personnel from a
specialist company. The following information is intended for specialists who
are familiar with the guidelines and safety precautions to be applied.
6.1

Prescribed installation method

The condenser unit (fig. 2 2, page 3) is attached to the firm and straight rear
panel of the cab or by means of a firm fastening frame. The evaporator unit
(fig. 2 1, page 3) is fitted on the inside of the rear panel of the cab.
The evaporator unit must be installed in an upright position (fig. 3, page 3).
I
NOTE
The connection line (fig. 2 3, page 3) can only be installed after fitting the
evaporator unit and the condenser unit.
The parking cooler consists of the following components (fig. 2, page 3):
• CoolAir SP950C condenser unit (1)
• CoolAir SP950I rear panel evaporator unit (2) with connecting line (3)
16
CoolAir SP950I
EN