Sealing And Attaching The Cover - Dometic COOLAIR SP 950I Instrucciones De Montaje

CoolAir SP950I
6.5

Sealing and attaching the cover

A
NOTICE!
When bending the supply line make sure that the radius is not too narrow. Use
a suitable round object with a shim as a bending aid.
A radius which is too narrow will kink the refrigerant line, and this will prevent
the parking cooler from operating.
I
NOTE
If you wish to avoid damaging the cab's rear panel (drilling a hole), you can also
fix the hood in place using a suitable adhesive. Observe the instructions
provided by the adhesive manufacturer.
➤ Align the cover over the line outlet.
➤ Drill 4 holes (Ø 3 mm) through the fastening edge of the hood up to the cab's
rear panel.
➤ Drill the holes in the hood's fastening edge (not the cab's rear panel) to
Ø 4 mm.
➤ Insert a holder on the corrugated pipe in the lower end of the hood for fixing
the protective tube in place.
➤ Apply body sealing compound to the fastening edge of the cover, the
through-holes of the connection line and the condensation hose.
➤ Apply the cover at the previously determined position and fasten it using the
supplied self-tapping screws. Make sure that the protective tube is fixed in
place by the holder in the hood (fig. 8, page 6).
➤ Seal all threaded connections used for mounting the parking cooler.
EN
Installation
21