Al2-2Pt-Adp - Mitsubishi a2 Serie Manual Del Usuario

α
2 Simple Application Controllers
12.

AL2-2PT-ADP

The AL2-2PT-ADP PT100 adaptor module (hereafter called "AL2-2PT-ADP") should be used to
amplify PT100 temperature input to 0 ~ 10V voltage analog signal for use in the main unit.
Further information can be found in the AL2-2PT-ADP Installation Manual.
Caution
• Persons trained in the local and national electrical standards must perform all tasks
associated with wiring the
α
• The 2 Series is not designed to be used in life critical or fail safe applications.
• Under no circumstances will Mitsubishi Electric be liable or responsible for any
consequential damage that may arise as a result of the installation or use of this
equipment.
EMC Caution
Mitsubishi Electric
European standards and directive. However, (for the very best performance from what are in
fact delicate measuring and controller output devices) Mitsubishi Electric would like to make
the following points:
• As analog modules are sensitive by nature, their use should be considered carefully. For
users of proprietary cables (integral with sensors or actuators), these users should follow
those manufacturers installation requirements.
• Mitsubishi Electric recommends that shielded cables should be used. If NO other EMC
protection is provided, then users may experience temporary errors not exceeding
+10%/-10% in very heavy industrial areas. However, Mitsubishi Electric suggest that if
adequate EMC precautions are followed with general good EMC practise for the users
complete control system, users should expect normal errors as specified in each
independent product manual.
α
2 Series Controller and AL2-2PT-ADP .
α
2 Series Analog modules has been found to be compliant to the said
AL2-2PT-ADP 12
ENG
ENG-61