Speaker Settings - Yamaha DSP-AX2 Manual De Instrucciones

This unit has seven SPEAKER SET items in the SET MENU that you must set according to the number of speakers in your configuration
and their size. The following table summarizes these SPEAKER SET items, and shows the initial settings as well as other possible settings. If
the initial settings are not appropriate for your speaker configuration, change the settings in the SET MENU.
Summary of SPEAKER SET items 1A through 1G
Item
1A. CENTER SP Selects the Center channel output mode according to the size of the Center speaker.
The possible settings are LRG (large), SML (small), and NONE.
1B. MAIN SP Selects the Main channel output mode according to the size of the Main speakers.
The possible settings are LARGE and SMALL.
1C. REAR L/R SP Selects the Rear channel output mode according to the size of the Rear speakers.
The possible settings are LRG (large), SML (small), and NONE.
1D. REAR CT SP Selects the Rear Center channel output according to the size of the Rear Center speaker.
The possible settings are LRG (large), SML (small), and NONE.
1E. LFE/BASS OUT Selects a speaker for the LFE/Bass signal output.
The possible settings are SWFR (subwoofer), MAIN, and BOTH.
1F. FRNT EFCT SP Selects the Front Effect signal output mode for the Front Effect signals.
The possible settings are YES and NONE.
1G. MAIN LEVEL Selects the output level for the Main channel signal.
The possible settings are Normal and –10 dB.
Note:
• When you adjust the balance of the output level from the Right and Left Main speakers, use "L/R BALANCE" on the SET MENU.

Speaker Settings

Description Initial Setting
LRG
LARGE
LRG
LRG
BOTH
YES
Normal
21