General Guidelines - Velleman VTUSCT2 Manual Del Usuario

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

Familiarise yourself with the functions of the device before actually using it.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Keep this manual for future reference.
4. Features

for cleaning of: jewellery, dentures, eyeglasses, electric shaver heads, printer heads, etc.

digital timer control system: 90s - 180s - 280s - 380s - 480s

accessories: basket, watch holder.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 lid
2 max. level indication
3 tank
6. Operation
1. Open the lid [1] and place the object to be cleaned in the basket [6], or use the watch holder [5].
Note: If you put in more than one object, make sure the items do not touch each other to prevent
scratches from rubbing.
2. Fill the tank [3] with tap water. The water has to cover the object, but must not exceed the MAX
mark [2].
Caution: Only use the cleaner when the tank is filled with water. Running the device without water
can cause irreparable damage.
3. Close the lid.
4. Connect the cleaner to the mains using the power cord.
The blue light in the lid lights. The display [4] shows 180 (=180 seconds). This is the most common
working cycle.
5. Press SET to select another cycle if desired.
6. Press ON to start the cleaning process.
The blue light around the control panel [4] lights and the timer counts down. You also hear the
cleaner buzz.
The cleaner automatically stops and the light around the control panel switches off when the timer
reaches 000.
7. Press OFF to manually stop the cleaning process.
8. When finished, unplug the cleaner from the mains and take the object out of the tank.
9. Remove the water from the tank and dry the cleaner.
Note: To prolong the life span of the device, we recommend that you switch the device off for
15 minutes after every 3 working cycles.
V. 02 – 26/02/2016
VTUSCT2
4 control panel and display
5 watch holder
6 basket
4 ©Velleman nv