Specifications; Applications; Charging Method - Hitachi UC10SL2 Manual De Instrucciones

English

SPECIFICATIONS

Input power source
Charging time
Charger
Weight

APPLICATIONS

For charging the HITACHI batteries type BCL10 series.

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
8
Single phase: AC120V 60Hz
BCL1015S .......................... Approx. 25 minutes
BCL1015 ............................ Approx. 30 minutes
BCL1030 ............................ Approx. 60 minutes
Charging voltage .............................. DC 10.8 V
Charging current .............................. DC 3.0 A
0.8 lbs (0.35 kg)
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.