Kenwood HYUNDAI 00271-13000 Manual De Instrucciones página 30

Installation
■ Installing in Japanese-Made Cars
1
Refer to the section <Removing the hard rubber frame> (page
31) and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
N
T
N
T/N
T
T: Toyota cars
N: Nissan cars
• During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
8 mm
8mm
MAX.
MAX.
2
3
ø5mm
ø5mm
Accessory2...for Nissan car
Accessory3 ...for Toyota car
— 30 —
■ Screwing the Faceplate on the Unit
If you want to fasten the
faceplate to the main unit so
that it does not fall off,
screw in the provided
screws (ø4 X 16 mm) in the
holes shown below.
Never insert the taptite screw (ø4 × 16 mm) in any other screw hole
than the one specified. If you screw it in another hole, it will contact
and may cause damage to the mechanical parts inside the unit.
Accessory4
Bottom panel