Correct Use - Ilmvac ROdist basic Serie Instrucciones De Manejo

• Ensure that the IR interface (RObath digital) is not soiled.
• Beware of hazards due to flammable materials.
• Only process media that will not react dangerously to the extra
energy produced through processing. This also applies to any
extra energy produced in other ways, e.g. through light irradiation.
• Do not operate the appliance in explosive atmospheres, with
hazardous substances or under water.
• Refer to the operating instructions for the accessories.
• Safe operation is only guaranteed with the accessories descri-
bed in the "Accessories" chapter.
• Use the HB 10.2 cover or the HB 10.1 spray guard.
• Always disconnect the plug before fitting accessories.
• The appliance RObath basic does start up again automatically
following a cut in the power supply.
• The device is only disconnected from the power supply network
if the device power switch is off or the plug is pulled out.
• The socket for the mains cord must be easily accessible.
For protection of the equipment
• The voltage stated on the type plate must correspond to the mains
voltage.
• Socket must be earthed (protective ground contact).
• Protect the appliance and accessories from bumps and impacts.
• The appliance may only be opened by experts
16
Unpacking
• Unpacking
- Please unpack the device carefully
- In the case of any damage a fact report must be set immedia-
tely (post, rail or forwarder)
• Delivery scope
- RObath basic - RObath digital
- Heating bath - Heating bath
- Mains cable - Mains cable
- Manual - Manual

Correct use

• Use
Tempering the media in the bath container.
Use with the ROdist series of rotary evaporators.
• Range of use
- Laboratories - Schools
- Pharmacies - Universities
The safety of the user cannot be guaranteed if the appliance is
operated with accessories that are not supplied or recommended
by the manufacturer or if the appliance is operated improperly con-
trary to the manufacturer's specifications.
2009-03-18