Error Message Robath Digital - Ilmvac ROdist basic Serie Instrucciones De Manejo

Error message RObath digital

Any malfunctions during operation will be identified by an error message on the display (H), see fig. 6.
Proceed as follows in such cases:
☞ Switch off device using the main switch (B)
☞ Carry out corrective measures
☞ Restart device
Error message
E 2
E 3
E 9
E 21
E 23
E 24
E 25
E 26
E 27
E 28
E 29
E 30
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the service department
- Send the device for repair, including a short description of the fault.
2009-03-18
Cause
- In remote operation (PC), no communication
between ROdist and RObath
- IR connection to ROdist disconnected
- Temperature inside the device is too high
- Fault in storing the safety circuit set temperatures-
- Memory chip (EPROM) defective
- Safety relay does not open
- Adjustable safety circuit defective
- Set safety temperature exceeded
- The heater control circuit switch (TRIAC) is faulty
The heater or the supply line is disconnected
- Dry running
- Error in calibration
- Breakage of the controller sensor
- Short-circuit in the safety sensor
- Short-circuit in the controller sensor
Effect Correction
Heating off - Switch off the device
- Clean the IR interface or
remove objects from around the IR interface
- Switch on the device
Heating off - Switch off the device
- Let the device cool down
- Switch on the device
Heating off - Switch off the device
- Let the device cool down
- Switch on the device
Heating off - Switch off the device and switch on again
Heating off - Switch off the device and switch on again
- Allow the device to cool down
- Switch on the device
Heating off - Switch off the device and switch on again
- Allow the device to cool down
- Switch on the device again
- Check the safety temperature setting
Heating off - Switch off the device and switch on again
Heating off - Let the device cool down
- Fill up the tempering medium
- Switch off the device and switch on again
Heating off - Switch off the device and switch on again
Heating off - Switch off the device and switch on again
Heating off - Switch off the device and switch on again
Heating off - Switch off the device and switch on again
23