Accessories/ Installation Procedure - Kenwood KTC-HR100TR Manual De Instrucciones

Accessories/ Installation Procedure

Accessories
1
2
3
4
5
6
10
|
English
Installation Procedure
1. To prevent short circuits, remove the key from
the ignition and disconnect the - terminal of
the battery.
2. Install the FM/AM antenna and connect the
..........1
antenna wire to the HD Radio tuner.
3. Connect the HD Radio tuner and the control unit
using the provided connection wire.
4. Make the proper input and output wire
connections for each unit.
5. Install the unit in your car.
..........2
6. Reconnect the - terminal of the battery.
7. Press the reset button on the control unit.
..........4
• Do not connect the control wire while the control unit is
turned ON.
• Be sure to press the reset button on the control unit after
installation.
• If your car is not prepared for this special connection-
system, consult your Kenwood dealer.
..........4
• Make sure that all wire connections are securely made by
inserting jacks until they lock completely.
• Do not let unconnected wires or terminals touch metal
on the car or anything else conducting electricity. To
prevent short circuits, also do not remove the caps on
the ends of the unconnected wires or the terminals.
..........2
• Insulate unconnected wires with vinyl tape or other
similar material.
• Take care so that the antenna wire and other connection
wires are not caught by mobile parts. Otherwise wire
disconnection or other trouble may result.
• Do not apply too much force on the antenna wire, other
..........1
connection wires and connectors by bending a wire,
etc. Otherwise wire disconnection or other trouble may
result.
• After the unit is installed, check whether the brake lamps,
indicators, wipers, etc. on the car are working properly.