Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Installation
1
Confirm the mounting position.
2
Place template (accessory 8) on Mounting
Surface. Mark each location to be drilled.
3
Cut the mounting surface.
Remove the template (accessory 8).
Mounting Surface
• When making a hole in the vessel, check that there is
nothing hazardous on the opposite side such as a pipe ,
or wiring harness, and be careful not to cause scratches
or other damage.
• Machine the surface to specified dimensions. Otherwise,
the unit might not be secured fully, or damage might
result.
4
Attach the packing (accessory 2).
Template (Accessory8)
Accessory2
5
Attach the Foam Tape (accessory 7).
6
Attach the drip shield (accessory 6).
Accessory7
Accessory6
Accessory2
7
Secure the main body with screws (accessory 5)
and brackets (accessory 4). Orient the brackets
with the "INSIDE" arrows facing inward.
8
The screws (accessory 5) tightening torque is
thing of 0.74 N•m ± 0.24 N•m (7.5 kgf-cm ± 2.5
kgf-cm) or less.
INSIDE
Screw (M4 × 50mm)
Washer
(Accessory5)
9
Attach the side cover (accessory 3).
Remote controller
Refer to the instruction manual of Remote
controller.
Accessory4
Mounting
Surface
Accessory3
|
31
English
Publicidad
Capítulos
Tabla de contenido
