Intended Use; Location Of Controls; Unpack Device; Assembly / Disassembly - Clatronic HM 3524 Instrucciones De Servicio

WARNING: Risk of injury!
• Do not repair the device by yourself. Please contact authorized personnel.
In order to avoid hazards, a damaged mains cable must be replaced with
an equivalent cable by the manufacturer, our customer service or any other
qualified specialist.
• This appliance shall not be used by children.
• Keep the appliance and its cord out of reach of children.
• Children shall not play with the appliance.
• Appliances can be used by persons with reduced physical, sensory or men-
tal capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and
if they understand the hazards involved.
• This device must not be immersed in water for cleaning. Please follow the
instructions provided in chapter "Cleaning".

Intended Use

This appliance is intended for mixing, stirring, beating, pureeing
or cutting food. It is suitable for processing common household
quantities.
It is only designed for this use and should only be used for this
intended purpose.
Only use this device as instructed in this user manual. Do not
use this device commercially.
No other use is intended and can cause damage or personal
injuries.
The manufacturer is not responsible for any damages incurred
due to improper use.

Location of Controls

1 Eject button for dough hooks and beaters
2 Switch
• On/Off switch
• Switch for speed settings 1 to 5
3 TURBO button
4 Blender stick
5 Knife
6 Fixture with cover for attaching the blender stick
7 Beaters
8 Dough hooks
9 Ring marking

Unpack Device

1. Take the device out of its packaging.
2. Remove all packaging materials, such as foils, filling mate-
rials, cable ties and cartons.
3. Check that all accessories are included in the box.
4. If the contents of the box are incomplete or if damage is
found, do not operate the appliance. Return it to the dealer
immediately.
NOTE:
Clean manufacturing residues and dust from the device as
described under "Cleaning".

Assembly / disassembly

CAUTION:
Safety mechanisms prevent the simultaneous assembly of
the blender stick and the dough hooks / beaters. Do not try to
bypass them!
Assembly of dough hooks / beaters
NOTE:
• For safety reasons, the fixtures for the dough hooks /
beaters will lock once the blender stick is attached.
• The dough hook and the beater with the ring marking on
their shaft must only be attached to the larger fitting of
the mixer. The other dough hook and beater are intended
for the smaller fitting. The two dough hooks and the two
beaters must not be attached without following these
instructions.
31