Audiovox VME 9312 TS Manual De Usuario página 69

Switch to Radio Tuner source
• Touch the top left corner of the screen (the RADIO circle) to view the SOURCE MENU. Touch "Radio".
• Press the SRC button (6) on the front panel or remote control (8) to switch to the AM/FM or RADIO source.
Select FM/AM Band
Touch the BAND button (15) on the screen, or press the BAND button on the unit (4) or remote control (20) to change
between the following bands: FM1, FM2, FM3, AM1, and AM2
NOTE: The BAND button on the unit only works when the TFT is closed.
Seek Tuning
To seek the next higher station:
• Touch the >>| button on screen.
• Press the >>| button (19) on remote control.
• Press the > button on the joystick (17).
To seek the next lower station:
• Touch the |<<| button on screen.
• Press the |<< button (17) on the remote control.
• Press the < button on the joystick (16).
Manual Tuning
To increase or decrease the tuning frequency one step:
v
• Touch the or buttons on screen.
^ ^
v
• Press the >> or << buttons (14, 22)on the remote control.
• Press the /\ or V buttons (18, 19) on the joystick.
Enter the desired radio station using the on-screen numberpad. Press the enter button (arrow) to tune to the selected
station. To exit the screen without changing the station, touch Exit. To clear your entry and start over, touch Clear.
Using Preset Stations
Six numbered preset buttons store and recall stations for each band. All six stored stations (P1-P6) for the current
band appear on the screen.
Storing a Station
1. Select a band (if needed), then select a station.
2. Touch the on-screen MEM button (18) to open the preset screen.
3. Touch the preset number in which you would like to store the current station (or
press EXIT to cancel and close the menu). The preset number and station
appears highlighted.
Direct Tuning
To enter a radio station directly, touch the button.
69