Connecting; Parameter Adjustment; Diagnosis, Asset Management And Service; Maintenance - Vega VEGAPULS WL S 61 Manual De Instrucciones

•
Operating system Windows 10
•
DTM Collection 05/2019 or newer
•
Bluetooth 4.0 LE or newer
Activate Bluetooth connection
Activate the Bluetooth connection via the VEGA
project assistant.
Note:
Older systems do not always have an
integrated Bluetooth LE. In these cases,
a Bluetooth USB adapter is required.
Activate the Bluetooth USB adapter
via the VEGA project assistant (see
supplementary instructions "Bluetooth
USB adapter").
After activating the integrated Bluetooth or the
Bluetooth USB adapter, devices with Bluetooth
are found and created in the project tree.
7.2

Connecting

Connecting ...
Select the requested device for the online para-
meter adjustment in the project tree.
Authenticate
The window "Authentication" is displayed. For
the first connection, the PC and the sensor
must authenticate each other. After successful
authentication, the next connection functions
without authentication.
Enter PIN
For authentication, enter in the next menu win-
dow the 4-digit PIN.
Note:
If an incorrect sensor PIN is entered,
the PIN can only be entered again after
a delay time. This time gets longer after
each incorrect entry.
Connected
After connection, the sensor DTM appears.
If the connection is interrupted, e.g. due to a too
large distance between sensor and PC, this is
displayed on the PC. The message disappears
when the connection is restored.
Change sensor PIN
It is recommended to change the default setting
of the sensor PIN to your own sensor PIN. To do
VEGAPULS WL S 61 • 4 ... 20 mA

8 Diagnosis, asset management and service

this, go to the menu "Additional adjustments",
menu item "PIN".
7.3

Parameter adjustment

Prerequisites
For parameter adjustment of the instrument
via a Windows PC, the configuration software
PACTware and a suitable instrument driver
(DTM) according to FDT standard are requi-
red. The latest PACTware version as well as all
available DTMs are compiled in a DTM Collec-
tion. The DTMs can also be integrated into other
frame applications according to FDT standard.
Abb. 22: Example of a DTM view - Setup, sensor
adjustment
8 Diagnosis, asset manage-
ment and service
8.1

Maintenance

Maintenance
If the device is used properly, no special mainte-
nance is required in normal operation.
Cleaning
The cleaning helps that the type label and mar-
kings on the instrument are visible.
Take note of the following:
•
Use only cleaning agents which do not cor-
rode the housings, type label and seals
•
Use only cleaning methods corresponding
to the housing protection rating
29