Speaker System Hookups - Sony SDP-E300 Manual De Instrucciones

Getting Started
Hookups
The arrow ç indicates signal flow.
Audio system
Connect the PRE OUT, ADAPTER OUT, or TAPE REC jacks
on your control amplifier to the LINE IN jacks on the
processor.
Processor
L
R
AUDIO
IN
LINE
CD player (etc.)
Connect the LINE OUT jacks on your CD player (etc.) to the
LINE IN jacks on the processor.
Processor
L
R
AUDIO
IN
LINE

Speaker System Hookups

Overview
This section describes how to connect your speakers to
the processor. Although you can connect rear and
centre speakers directly to the processor, front speakers
must be connected through a separate amplifier (as
shown below). Connecting an active woofer will
increase bass response.
For specific locations of the terminals, see the
illustration below.
FRONT OUT
SURROUND
REAR/CENTER out
For optimum surround sound effect, place your
speakers as shown below.
45°
GB
6
Control Amplifier
PRE OUT
L
R
CD Player (etc.)
LINE OUT
L
R
REAR SPEAKERS
SURROUND CENTER SPEAKERS
MIX out
Rear
60 - 90 cm
Front
What cords will I need?
Audio cord (not supplied) (1) (for the amplifier powering
the front speakers)
White (L)
Red (R)
What cords will I need?
Speaker cord (not supplied) (1 for each rear speaker and one
for the centre speaker)
(+)
(–)
Twist the stripped ends of the cord about 2/3 inch (15 mm).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
Hookups
Front speakers
Processor
(for front speakers)
L
R
OUT
FRONT
Rear and centre speakers
Rear speaker
(R)
Processor
} ]
R L
REAR CENTER
SPEAKERS
Active woofer
Processor
CENTER
REAR MIX
SURROUND
White (L)
Red (R)
(+)
(–)
Amplifier
AUX
INPUT
L
R
Rear speaker
(L)
Centre speaker
} ]
} ]
Active woofer
INPUT