Basic Functions; Switching On And Off; Tuning To Radio Stations - Philips AZ1550/00 Manual De Instrucciones

AZ 1550 /00 6
page

BASIC FUNCTIONS

SWITCHING ON AND OFF

• Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE.
• The set is switched off when the POWER slider is in the
TAPE/OFF position and the keys on the tape deck are released.
– The volume, sound settings and tuner presets will be retained
in the set's memory.
ADJUSTING VOLUME AND SOUND
1. Turn the VOLUME/ SOUND CONTROL CENTER control
clockwise to increase or anti-clockwise to decrease volume on
the set.
™ Display shows the volume level indication, VOL and a number
from 0-32.
2. To adjust the bass, mid and high frequency levels, press
DIGITAL EQUALIZER once or more until the desired option is
displayed. While the option is shown, turn the VOLUME/
SOUND CONTROL CENTER control to increase or decrease
(- 5 to + 5 steps maximum) the desired tone.
™ VOLUME can also be adjusted in this way with a level range
from 0-32.
3. Press DIGITAL DBB to switch dynamic bass boost on or off.
™ If on, the DIGITAL DBB light goes on.
4. Press INCREDIBLE SURROUND to switch the surround sound
effect on or off.
™ If on, the INCREDIBLE SURROUND light goes on.
Note: The effect of INCREDIBLE SURROUND may vary with
different types of music.

TUNING TO RADIO STATIONS

1. Select TUNER source.
2. Press BAND once or more to select your waveband.
3. To tune to a radio station, use the TUNING knob.
To improve radio reception:
• For FM, pull out the telescopic aerial.
Incline and turn the aerial. Reduce its length if the signal is too
strong (very close to a transmitter).
• For MW and LW, the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
6
TUNER
+
•
•
•
•
0
•
•
•
•
–