Disposal Of The Battery - Philips QC5050/01 Manual Del Usuario

English
10
5 Also clean the inside of the appliance with the brush
supplied (Fig. 11).
6 Place the lug of the cutting unit into the slot and push the unit back
onto the appliance ('click') (Fig. 1).
This appliance does not need any lubrication.
replacement
A worn or damaged cutting unit should only be replaced with an original
Philips cutting unit.
Push the middle part of the cutting unit upwards with your thumb
,
until it opens and then pull it off the appliance (Fig. 9).
Be careful that the cutting unit does not fall to the floor.
Place the lug of the new cutting unit into the slot and push the unit
,
back onto the appliance ('click') (Fig. 1).
Environment (QC5050 only)
Do not throw the appliance away with the normal household waste
,
at the end of its life, but hand it in at an official collection point for
recycling. By doing this you will help to preserve the
environment (Fig. 1).
The built-in rechargeable battery contains substances that may pollute
the environment. Always remove the battery before discarding the
appliance or handing it in at an official collection point. Dispose of the
battery at an official collection point for batteries. If you have trouble
removing the battery, you can also take the appliance to a Philips service
centre, which will remove the battery for you and will dispose of it in an
environmentally safe way.

disposal of the battery

Only remove the battery if it is completely empty.
1 Disconnect the appliance from the mains and let the appliance run
until the motor stops.
 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (Fig. 9).
4203.000.5452.3.indd 10 12-03-2007 14:33:22