Optimising The Lifetime Of The Battery; Corded Clipping; Clipping With Comb Attachment - Philips HQC486/00 Manual De Instrucciones

All manuals and user guides at all-guides.com

Optimising the lifetime of the battery

- Discharge the battery completely twice a year by letting the motor
run until it stops.
- Do not keep the cord plugged into the wall socket all the time.
- If the appliance has not been used for a long period of time, it must
be recharged for at least 12 hours.

Corded clipping

To use the hair clipper connected to the mains:
Switch the hair clipper off, connect it to the mains and wait a few
seconds before switching it on.
If the battery is completely empty, wait a few minutes before switching
the appliance on.
Do not run the appliance from the mains when the battery is fully
charged.
Preparing for clipping

Clipping with comb attachment:

1 Slide the comb attachment onto the rails on the appliance until
you hear a click.
Select the small or large comb attachment, depending on the desired
hair length (see table).
2 Make sure that the arms of the comb attachment have been
properly slid onto the rails on both sides.
Hair length settings
The hair length settings are indicated in millimetres on the arms of the
comb attachment.The settings correspond to the remaining hair length
after cutting.
small comb large comb
hair length hair length
3 mm 23 mm
6 mm 26 mm
9 mm 29 mm
12 mm 32 mm
15 mm 35 mm
18 mm 38 mm
21 mm 41 mm
For clipping techniques, see the booklet supplied with the
appliance.
ENGLISH
5