Waeco PerfectView CAM30 Instrucciones De Montaje página 24

CAM30_CAM40.book Seite 24 Donnerstag, 14. Januar 2010 5:32 17
Mounting the camera
If you would like to attach the bottom camera holder with threaded screws fitted
through the construction
Caution!
a
Ensure that nuts cannot be pulled through the body shell when they are tight-
ened.
Use larger washers or metal plates if necessary.
➤
Drill Ø 5.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤
Place the insulating plate (fig. 3 5, page 3) where the bottom camera holder is to be
fitted.
The insulation plate serves as a seal and protects the paint.
➤
Screw the camera holder on with the M5 x 25 mm threaded screws (fig. 7 A,
page 5).
Depending on the thickness of the construction, you may require longer threaded
screws.
Fastening the camera
➤
Push the camera into the bottom camera holder.
Note
I
Remember that the LDR sensor (fig. 4 5, page 4) must face downwards so that
the picture is correctly shown on the monitor.
➤ Fasten the camera loosely using the top camera holder and the two M3 x 12 mm
screws (fig. 7 B, page 5).
Note
I
Do not tighten the two screws until you have aligned the camera (see chapter
"Checking the function and setting the camera" on page 25).
To do this you must first install and connect a monitor (see the connection dia-
gram fig. 9, page 5).
Creating a through-hole for the camera connection cable
Note
I
If possible, use available openings – such as ventilation grilles – to feed the con-
nection cables through. If there are no existing openings, you must drill a hole
with a 13 mm diameter. Check beforehand that there is sufficient room for the
drill head to come out on the other side.
➤
Drill a hole of Ø 13 mm near the camera.
➤
Deburr all drill holes that have been made in the sheet metal and apply rust-protec-
tion.
➤
Seal the duct with the sleeve (fig. 4 3, page 4).
24
PerfectView