Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
3
4
7
2
1. Motor.
10
2. Gear box.
3. Head housing.
4. Tube fastener adjustment.
5. Tube fastener (clamp).
6. Bolt.
7. Reverse speed lever.
8. ON switch.
9. Brush housing.
10. Machine identification plate.
11. Adapter monoblok 1/4" -1.1/4"
12. Adapter euroblok 1/4" -1.1/4"
OPERATION INSTRUCTIONS
1. Before carrying out any operations with the
machine, first read the general safety instruc-
tions and preparations for start up.
2. Fasten the tube clamp securely and check
that the machine is anchor bolt is parallel to
the tube to be threaded. The bolt should ex-
tend over the end of the tube by approximate-
ly 1 or 1.5 cm.
3. Choose the threading head according to
your needs and mount it in the octagonal
coupling of the machine. Fit the adapter first,
when using a 1.1/4" head. For right thread,
insert the threading head ad the front of the
machine. For left thread, insert the threading
head at opposite end of the machine.
4. When using the adapter, this should be di-
rectly inserted in the octagonal coupling of the
machine on the same in which the threading
head has been inserted (right thread: front
5
12
11
6
9
1
8
E N G L I S H •
side; left thread: opposite side) and secured by
its threaded cap.
5. To insert the head into the adapter, move
the mobile part of the latter counter-clockwise
until it is completely inserted. This will spring
back securing the head. To remove it, proceed
in likewise manner.
6. Next insert the machine in the tube and
make sure that it is securely guided into its
housing by the tube clamp bolt.
7. Check that the reverse gear lever is correctly
in place (arrow in working direction). Press the
electric switch with your right hand. Rotation
will start immediately. Now the head should be
moved towards the tube to start the threading
process by pressing on the machine.
8. As soon as threading has begun, the head
should be constantly and abundantly lubricat-
ed with threading oil.
9. Once the appropriate threading length has
been achieved (the tube of the threading head
should never overhang in a normal thread),
stop the motor. Change the position of the re-
verse gear lever and start the motor. The ma-
chine will begin to unscrew the head and the
tube will become free.
ATTENTION: Fast
speed must only be
used to unscrew the
head.
Never thread
on fast speed.
MAINTENANCE
Before carrying out any job on the machine,
disconnect the plug from the mains outlet.
1. Cable and plug. Both the cable and plug
should be in optimum condition. Check them
at regular intervals.
2. ON switch. Check that the machine switch
unblocks automatically when finger pressure is
released. In case of any anomaly, replace im-
mediately with a new one.
3. Brushes. Check frequently for brush wear
and perfect contact with rotor. Change brush-
es when their length is 1/3 of original length.
4. Motor and rotor. The carbon dust accumu-
lated in the motor and brush housing should
U se r's m a n ua l
10
Publicidad
Tabla de contenido
