Teka DG2-ISLA Manual De Instrucciones página 12

Cleaning and maintenance
During cleaning and maintenance work, make
sure the safety instructions set out on page 10
are complied with.
Cleaning the hood body
• If your kitchen hood is made from stainless
steel, use proprietary cleaners mentioned
in the product instructions.
• Never use metallic scourers, nor abrasive
or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• The use of vapour cleaners is not
recommended.
Cleaning the metal filters
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
_________________________________________________________
Proceed with the following checks before calling the Technical Service:
See page 62.
TEKA INDUSTRIAL S.A. reserves the right to make changes and corrections to its products as
it deems necessary, without altering their basic characteristics.
12
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Fig. 1 (Page 63)
Proceed as follows:
• Unscrew the lamp trim cover.
• Change the broken/ burnt out lamp.
Maximum lamp power is 20 W (G-4).
• Screw the lamp trim cover.
Problem solving
Sizes and specifications
Changing light bulbs