Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
A, MowerSide Sus _ension Arms
Q. DeflectorShield
5. INSTALL ANTI-SWAY BAR (S)
(IF EQUIPPED)
'
ANTI-SWAY
BAll
(S)
Ldi" Towards
Towards"_
I ""_ Transaxle
MowerDeck
90° End
IntegratedWasherEnd
6,
•
From right side of mower, first insert
90_ end of anti-sway bar (S) into hole in
transaxle bracket (T), located near left
rear tire in front of transaxle,
NOTE: Flashlight may be helpful.
"t
t3
Anti-Sway
! _
!.,'-__............... _,_
°
Bar(S)
_,._.:: :_:.>
._
Location...,
] ;
\
Transaxle Bracket (T)
Located Between Rear Tires
T. Transaxle Bracket
NOTE: Depending onmodel, bracket (_ may
be differentthan shown but hole for anti-sway
bar wilt be in same position!location,
•
Pivot the integrated washer end of anti-
sway bar (S)towards mower deck bracket
on right side of mower, Insert integrated
washer end of bar into hole in rear mower
bracket (D). Move mower as needed to
insert integrated washer end of bar into
rear mower bracket (D),
•
Secure with small washer and small
retainer spring as shown.
D,
Right Side Rear Mower Bracket
S.
Anti-Sway
Bar
T.
Transaxle
Bracket
ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS
Position front hole inside suspension arm
(A) over pin on outside of tractor chassis
and secure with large washer and large
retainer spring (B),
Repeat on opposite side of tractor.
A, Mower Side Suspension Arms
B. Retainer Spring
D. Right Side Rear Mower Bracket
7. ATTACH REAR LIFT LINKS (C)
•
Insert rod end of rear lift link (C) into hole
(U) in tractor lift shaft suspension arm
and pivot link down to mower,
•
Lift rear corner of mower and position slot
in link assembly over pin on rear mower
bracket (D) and secure with largewasher
and large retainer spring.
•
Repeat on opposite side of tractor.
10
Publicidad
Tabla de contenido
