Sears 917.28863 Manual De Instrucciones Para La Instalación Y El Uso página 30

REPLACING BATTERY
n_asWARNING: Do not short battery terml-
y allowing awrench or any otherobject
to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from accidental grounding.
1. Lift hoodto raised position.
2. Remove terminal cover.
3. Disconnect BLACK battery cable then
RED battery cable and carefully remove
battery from tractor,
4. Install new battery with terminals insame
position as old battery.
5. Reinstall terminal cover.
6. First connect RED battery cable to posi-
tive (+) battery terminal with bolt and nut
as shown. Tighten securely.
7. Connect BLACK grounding cable to
negative (-) batteryterminal with remain-
ing bolt and nut. Tighten securely
8. Close hood.
TO REPLACE HEADLIGHT BULB
1, Raise hood,
2. Remove bulb holderfrom the hole inthe
backside of the grill.
3. _Rep!afieI_u!b.!_3 ho!de_ arid ir_sta[!.__bu!_b .....
holder securely back into the hole inthe
backside of the grill.
4, Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2, Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to recon-
nect the headlight wire connector.
Hood
Headlight Wire
Connector
TRANSMISSION
REMOVAL/REPLACEMENT
Should your transmission require removalfor
service or replacement, it should be purged
after reinstallation and before operating the
tractor, See "PURGE TRANSMISSION" in
the Operation section of this manual.
ENGINE
TO ADJUST THROTTLE CONTROL
CAB LE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
Ine cnol{e control has been preset at
the factory and adjustment should not be
necessary, If adjustment is necessary, see
engine manual.
TO ADJUST CARBURETOR
Yourcarburetor has been presetatthefactory
and adjustment should not be necessary,
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or load. Ifthe engine does
need adjustment, see engine manual,
3O