JB Systems Light Plano Spot Manual De Instrucciones página 5

ENGLISH
JB SYSTEMS
®
OPERATION MANUAL
5/50 PLANO SPOT
ENGLISH
DMX512 Address Setting
Used to set the start address in a DMX setup, you can also automatically program the next PLANO
SPOT projectors in the same DMX-chain.
Program a DMX start address in 1 unit:
 Press the MENU button until
is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP buttons to change the DMX512 address.
 Once the correct address shows on the display, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
Automatically program the DMX start addresses of several units in a DMX-chain:
 Connect the DMX in/outputs of all projectors together and switch them all on
 On the first unit in the chain:
 Set the DMX-starts address as described above.
 After this, press the MENU button until
 Press the ENTER button to start the automatic programming  all units flash one time to indicate
that the addresses are automatically set, starting from the address programmed in the first unit.
 Press the MENU button on the first unit for about 2 seconds to return to running mode.
Example: the first projector was set to DMX-address 100  when you perform the automtic
addressing, the other projectors in the DMX-chain will receive addresses: 104, 108, 112, 116, ...
Channel Mode
The unit has 4 different channel modes, each with different functions for the 4
DMX-chart to see the differences.
 Press the MENU button until
is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP button to select one of the available channel modes.
 Once the mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
Show Mode
Used to choose to select one of the preprogrammed multi channel shows when used in standalone
or master/slave mode.
 Press the MENU button until
is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP buttons to select one of the preprogrammed shows:

 all shows played in random mode.
 to  12 different built-in shows.
 Except for the random show (Show 0) you will also be asked to select a running speed for the static mode.
With the UP/DOWN buttons you can select
 Once the right show is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
Color chase Mode
Used to choose to select one of the preprogrammed color chases when used in standalone or
master/slave mode. All projectors will always show an identical output.
 Press the MENU button until
is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP buttons to select one of the preprogrammed shows:

to  16 different built-in color chases.
  fading from one color to another.
 You will also be asked to select a running speed for the static mode. With the UP/DOWN buttons you can
select (slow) to (fast).
 Once the right show is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
JB SYSTEMS
®
OPERATION MANUAL
is shown on the display.
th
channel. Refer to the
(slow) to (fast).
6/50 PLANO SPOT