Troubleshooting - Dometic COOLFREEZE CDF16 Instrucciones De Uso

CoolFreeze CDF16
•
A reason for the claim or description of the fault
9

Troubleshooting

Fault
Device does not
function, LED does
not glow.
When operating from
the DC outlet:
The ignition is on
and the device is not
working and the LED
is not lit.
The device does not
cool (plug is inserted,
"POWER" LED flashes
orange, display is
switched off).
The display shows an
error message (e.g.
"Err1") and the appli-
ance does not cool.
EN
Possible cause
There is no voltage
present in the 12/24 V
socket (cigarette lighter)
in your vehicle.
The DC outlet is dirty.
This results in a poor
electrical contact.
The fuse of the DC plug
has blown.
The DC fuse inside the
device has blown.
The vehicle fuse has
blown.
Battery voltage is too
low.
The appliance has
switched off due to an
internal fault.
Suggested remedy
The ignition must be switched on in
most vehicles to apply current to the
cigarette lighter.
If the plug of your cooler becomes very
warm in the DC outlet, either the DC
outlet must be cleaned or the plug has
not been assembled correctly.
Replace the fuse in the DC plug, see
chapter "Replacing the plug fuse
(12/24 V)" on page 13.
This can only be repaired by an
authorised repair centre.
Replace the vehicle's DC outlet fuse.
Please refer to your vehicle's operating
manual.
Test the battery and charge it as needed.
This can only be repaired by an
authorised repair centre.
Troubleshooting
15