Samsung 400 Serie Manual Del Usuario página 36

Problem Possible Solution
Plasma TV is making humming no=se.
Image Retention (Burn In] issue.
Can not centre! TV power or volume
with Cable/Sat box remote control,
• Plasma TVs typically maKe a soft humming sound. This s normal. It's caused by tne
electrical charges that are used to create the images on tne screen.
• If the humming sound is loud you may have set the brightness on the TV too nigh.
Try setting the brightness lower.
• You can also have loud nummlng if the back of your Plasma TV is too close to a wal
or other hard surface. Also try rerouting your connection cables.
• Improper installation of wall mount can create excessive noise.
• To minimize the possibility of screen burn. this unit is equipped with screen burn
reduction technology. Pixe Shift technology enables you to set olcture movement up
down ,'Vertical Line and side to s_de Horizonta Dot
Program the Cable/Sat remote control to operate the TV.
Refer to Cable/Sat user manual for SAMSUNG TV code.
"Not Su pported Mode" message.
Caption on TV menu is greyed out,
Plastic smell from TV.
TV Signal Strength is unavailable in the
Self Diagnostic Test menu.
TV is tilted to right or left side,
Can not assemble stand base,
Channel menu is grey out (unavailable).
Your settings are lost after 30 minutes
or every time TV is turned off,
o
o
o
o
o
o
o
o
Intermittent loss of audio or video.
You may see small particles if you
look closely at the edge of the bezel
surrounding the TV screen.
Check the supporteo resotution of the TV and adjust the external device's cutout
resolution accordtngty. Refer to resolution settings _ this manual.
Caption can not be selected in the TV menu when connected via HDMI or
Comoonent.
Caption must be activated on tne external oevlce,
This smel is normal and will dtss pate over time.
This function is only available ,vttndigital channels with an Antenna (RF/Coax_
connection Air or Cable.
Remove the stand base from TV and reassemble.
Make sure TV is olaced on flat surface.
If can not remove screws from TV please use magnetized screw driver.
Channel menu is only available wnen TV source is selected ,Antenna or Cable
If TV is ntne Store Demo mode it wil reset audto and ptcture settings every
30 minutes.
Please change from Store Demo mode to Home Use mode n the Plug & Play
procedure.
Press tne SOURCE button to select TV mode go to MENU _ Setup _ Plug & Play
-- ENTER_
Check cable connections and reconnect.
Can be caused by using overly rigid or thick cables.
Make sure the cables are flexible enough for long term use.
If wall mounting, we recommeno ustng cables with 90 degree connectors.
This is part of the oroduct's destgn and ts not a defect.
Input cables (Not supplied)
HDMI HDMI/DVl Component Composite (AV) Coaxial (RF)